|
GTS OWNERS CLUB For all GTS GTV GT owners to have a chat
|
Important Notice:
We regret to inform you that our free phpBB forum hosting service will be discontinued by the end of June 30, 2024.
If you wish to migrate to our paid hosting service, please contact billing@hostonnet.com.
View previous topic :: View next topic |
Author |
Message |
smirnoff Site Admin
Joined: 14 May 2007 Posts: 1125 Location: On the bouncy castle in my head.
|
Posted: Fri May 18, 2007 8:33 pm Post subject: |
|
|
Maver wrote: | smirnoff wrote: | Ideally you also need a thin walled 11mm socket if you have a pm pipe. or get an old one on the grinder. |
i used a cut down 1/4 drive socket, wobble bar and universal joint, put the socket on the grinder until it was as shallow as possible, but i'm sure it's a 10mm........ |
You are right but the lammy brass nuts are 11mm so therefore less room. _________________
PHIL.... |
|
Back to top |
|
|
Maver Site Admin
Joined: 14 May 2007 Posts: 2193 Location: naaaaaarfolk we drive tractors and talk loike PIRATES
|
Posted: Fri May 18, 2007 8:39 pm Post subject: |
|
|
smirnoff wrote: | Maver wrote: | smirnoff wrote: | Ideally you also need a thin walled 11mm socket if you have a pm pipe. or get an old one on the grinder. |
i used a cut down 1/4 drive socket, wobble bar and universal joint, put the socket on the grinder until it was as shallow as possible, but i'm sure it's a 10mm........ |
You are right but the lammy brass nuts are 11mm so therefore less room. |
ah! now i understand, so we need shallow AND thin walled 11mm socket
cut down 1/4 drive ideal _________________
|
|
Back to top |
|
|
smirnoff Site Admin
Joined: 14 May 2007 Posts: 1125 Location: On the bouncy castle in my head.
|
Posted: Fri May 18, 2007 8:45 pm Post subject: |
|
|
Maver wrote: |
ah! now i understand, so we need shallow AND thin walled 11mm socket
cut down 1/4 drive ideal |
Its cos they are m7... odd size, but coincidentally the same as a Lammy. _________________
PHIL.... |
|
Back to top |
|
|
buddyphil Site Admin
Joined: 14 May 2007 Posts: 265 Location: page 34 febuary edition of scootering magazine
|
Posted: Fri May 18, 2007 8:52 pm Post subject: |
|
|
i got a 11mm 1/4 drive socket spun down a little on the lathe
at work |
|
Back to top |
|
|
smirnoff Site Admin
Joined: 14 May 2007 Posts: 1125 Location: On the bouncy castle in my head.
|
Posted: Fri May 18, 2007 8:53 pm Post subject: |
|
|
Keep it safe _________________
PHIL.... |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|